Radius Scupper 8 Inch Copper
$546.00
Estimated delivery by April 1 - April 9
Within 48 Contiguious States
Radius Scupper 8 Inch Copper
The Radius Scupper 8 Inch Copper is CNC machined, then bent and welded together. Each scupper starts as a sheet of high-grade copper and then it is measured, cut, and welded all by hand. Each piece is then finished off with a beautiful dark patina to elevate the look of the scupper. The Outdoor Plus’s ( TOP’s ) products are made in the USA to bring you the fastest lead times in the industry!
- Custom Sizes & Styles Available
- Suitable for Chlorine & Salt Water Pools
- Manufactured By Hand in the USA
- Dark Patina Coating Applied by Hand
- Lacquer Finish to slow down natural patina
- All Scuppers Include a port for ground wires
The Scupper is fitted with a 1 1/2-inch female water inlet and requires 7-9 GPM for every 12 inches of linear width. The Copper Radius Scupper is also available in 12, 24, 36, and 48 inches wide.
Installation:
- Make sure you have a scupper cavity that is 3/16” bigger than that of your scupper size in the width and height aspects.
- The handmade nature of the scupper might mean you have to adjust your measurements accordingly.
- Position the scupper into the scupper cavity according to the desired scupper overhang.
- The manufacturer recommends that you have a minimum of 2” of scupper wall/manifold inside of the scupper cavity.
- Make sure you ground your scupper with the grounding lug located in back of your scupper by connecting copper wire to the ground.
- Use a strong adhesive to hold down the scupper to the desired location.
- The inlet is 1.5” wide located in behind the scupper. Connect your PVC piping to the scupper inlet. PVC piping and water should use 10-12 GPM per linear foot of the scupper’s width. Increase GPMs to desired arch flow for further protrusions.
- Install a water ball valve on each scupper if you would like to adjust water output.
CARE
If scupper starts to become loose at any point repair with the adhesive and lock back into place.