...

Radius Scupper 36 Inch Copper

The Outdoor Plus
Part #: OPT-RSE36

Original price was: $1,180.00.Current price is: $1,072.00.

Estimated delivery by April 30 - May 9

Free Shipping Small Logo
Within 48 Contiguious States
Product Description
Product Reviews

Radius Scupper 36 Inch Copper

The Radius Scupper 36 Inch Copper is CNC machined, then bent and welded together. Each scupper starts as a sheet of high-grade copper and then it is measured, cut, and welded all by hand. Each piece is then finished off with a beautiful dark patina to elevate the look of the scupper. The Outdoor Plus’s ( TOP’s ) products are made in the USA to bring you the fastest lead times in the industry!

  1. Custom Sizes & Styles Available
  2. Suitable for Chlorine & Salt Water Pools
  3. Manufactured By Hand in the USA
  4. Dark Patina Coating Applied by Hand
  5. Lacquer Finish to slow down natural patina
  6. All Scuppers Include a port for ground wires

The Scupper is fitted with a 1 1/2-inch female water inlet and requires 7-9 GPM for every 12 inches of linear width. The Copper Radius Scupper is also available in 12, 24, 36, and 48 inches wide.

Radius Scupper 36 Inch Copper
Radius Scupper 36 Inch Copper
Radius Scupper 36 Inch Copper Dimensions
Radius Scupper 36 Inch Copper Dimensions

Installation:

  • Make sure you have a scupper cavity that is 3/16” bigger than that of your scupper size in the width and height aspects.
  • The handmade nature of the scupper might mean you have to adjust your measurements accordingly.
  • Position the scupper into the scupper cavity according to the desired scupper overhang.
  • The manufacturer recommends that you have a minimum of 2” of scupper wall/manifold inside of the scupper cavity.
  • Make sure you ground your scupper with the grounding lug located in the back of your scupper by connecting copper wire to the ground.
  • Use a strong adhesive to hold down the scupper to the desired location.
  • The inlet is 1.5” wide and located behind the scupper. Connect your PVC piping to the scupper inlet. PVC piping and water should use 10-12 GPM per linear foot of the scupper’s width. Increase GPMs to desired arch flow for further protrusions.
  • Install a water ball valve on each scupper if you would like to adjust the water output.

CARE

If the scupper starts to become loose at any point repair it with the adhesive and lock it back into place.

Customer Reviews

Be the first to write a review
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)